Advertisement
26. Using a utility knife, cut into the floor carpet at the
end of the cross member. Be careful not to
damage the wire harnesses routed under the floor
carpet.
UTILITY
KNIFE
FLOOR
CARPET
DRIVER'S
SEAT
27. Pull up the floor carpet, and route the subwoofer
harness under the floor carpet at the cross
member, and out through the cut you made in the
floor carpet as shown.
28. Secure the subwoofer harness to the vehicle
harness using one wire tie in the area shown.
29. SE models only: Remove the heated seat relay
from the driver's seat panel (one self-tapping
screw, and unplug the vehicle connector).
DRIVER'S
SEAT PANEL
HEATED SEAT
RELAY
© 2005 American Honda Motor Co., Inc. - All Rights Reserved.
CROSS
MEMBER
SUBWOOFER
HARNESS
WIRE TIE
FLOOR CARPET
OPENING
VEHICLE
HARNESS
4714051M
SELF-
TAPPING
4N18500K
SCREW
(Discard.)
AII 30529 (0509)
Installing the Subwoofer
30. Using scissors, cut one EPT sealer in half. Wrap
the two pieces of EPT sealer around the two
vehicle harnesses in the positions where they
contact the edge of the seat panel.
VEHICLE
HARNESS
31. Position the right and left brackets on the seat
panel under the driver's seat, and install the four
6 x 12 mm washer-bolts.
6 x 12 mm
WASHER-
BOLT
RIGHT
SUBWOOFER
BRACKET
LEFT
SUBWOOFER
BRACKET
BOLT
EPT SEALER
(Cut in half.)
DRIVER'S
SEAT PANEL
EPT
4720011M
SEALER
SEAT PANEL
6 x 12 mm
WASHER-
4413171K
BOLT
7 of 11
Advertisement
