Adjustments - Blodgett COS-6 Installation And Operation Manual

Export series combi-oven/steamer
Table of Contents

Advertisement

Installation

Adjustments

Before applying power to the unit for the first time,
check for the following conditions:
All electrical safety provisions have been ad-
j
hered to and the electrical connections are
correct.
Water is connected, turned on and all of the
j
connections are water tight.
The grease filter and holder are in their proper
j
positions.
The pan holders on models COS-6 and
j
COS-101 are inserted into the oven cavity.
Stationary rack guides are provided with mod-
el COS-101S.
For model COS-20E be sure that the transport
j
cart is inserted into the oven cavity correctly.
The door must be shut and the handle fully en-
gaged.
WARNING!!
If the fan turns in the wrong direction, the
appliance will not function properly and
can be damaged.
NOTE: The first time the unit is turned on, or after
it has been OFF for 5 hours and then
turned on, the boiler will automatically
flush for a period of 45 seconds. The boiler
will then fill to the proper water level. The
unit is now ready for operation.
DOOR ADJUSTMENT
COS-6, COS-101, COS-101S and COS-8E
The door latch may be adjusted in two directions,
in and out, and up and down, using the following
procedure:
1. Adjust up and down by loosening the two
bolts holding the latch to the face of the unit.
See Figure 11 (A).
2. Make adjustments so that the leading face of
the latch is centered in the opening of the han-
dle assembly.
3. Tighten the bolts so that there is no further
movement.
4. Adjust in and out by loosening the bolt on top
of the latch. See Figure 11 (B).
5. The adjustment face is stepped so that move-
ment is limited with the bolt tightened proper-
ly.
6. The adjustment is correct when the door
closes firmly and no steam leaks from the gas-
ket.
The hinges can also be adjusted as follows:
1. Be certain the latch is adjusted properly.
2. Adjust hinges so that the door back and the
unit face are parallel. See Figure 11 (C).
3. The adjustment is correct when no steam
leaks through the gasket.
COS-20E
The hinges may be adjusted using the following
procedure:
1. Adjust the top hinge plate by loosening the
three mounting bolts on the top right corner of
the oven.
2. Adjust the bottom hinge pin by loosening the
mounting bolt located under the bottom hinge
plate on the lower right corner of the oven.
3. Adjust the hinges so that the door back and
the unit face are parallel. See Figure 11 (D).
4. Tighten the bolts so that there is no further
movement.
5. The adjustment is correct when the door
closes firmly and no steam leaks from the gas-
ket.
The catch can also be adjusted as follows:
1. Adjust the door catch by loosening the four
mounting screws located on the inside sur-
face of the oven door.
2. The adjustment is correct when no steam
leaks from the gasket.
12

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cos-101Cos-101sCos-8eCos-20e

Table of Contents