Cleaning And Preventive Maintenance - Blodgett COS-6 Installation And Operation Manual

Maintenance

Cleaning and Preventive Maintenance

CLEANING THE INTERIOR
Daily cleaning of the appliance is essential for san-
itation, and to ensure against operational difficul-
ties. Use an oven cleaning detergent in conjunc-
tion with the supplied spray bottle.
For difficult cleaning, allow the spray-on oven
cleaner to work longer before rinsing.
1. Cool the oven down to 60_C (140_F) or, if the
oven has been idle, turn the steam mode on
for 3 to 4 minutes in order to warm the oven
surfaces.
2. Fill the spray bottle and pump air into the con-
tainer with the pressure pump.
3. Spray the interior of the oven with a cleaning
solution.
NOTE: Never spray water into the unit when
the temperature is above 100_C
(212_F). NEVER SPRAY WATER IN
THE UNIT AFTER USING THE HOT AIR
OR COMBI MODES.
4. Let the cleaner work for 10 to 20 minutes with
the oven off. For difficult, baked on grease,
etc. allow to work over night.
5. Set the timer for 15 to 20 minutes.
6. Set the mode selector switch to Steam. This
will soften all burned on residue.
7. Rinse the oven interior with water (a hose may
be used, but take care that only the oven's in-
terior cavity is sprayed with water).
8. Set themodeselectorto steamfor anotherfive
minutes to flush out the oven interior and re-
move all detergent residue.
NOTE: The oven cavity should never be scoured
or scraped.
On stainless interiors, deposits of baked on splat-
ter, oil, grease or light discoloration may be re-
moved with a good non toxic industrial stainless
steel cleaner. Apply cleaners when the oven is
cold and always rub with the grain of the metal.
The racks, rack supports and the blower wheel
may be cleaned in the oven or by removing them
from the oven and soaking them in a solution of
ammonia and water.
NOTE: DO NOT use corrosive cleaners on the
Oven/Steamer.
CLEANING THE EXTERIOR
Oven exteriors may be cleaned and kept in good
condition with a light oil. Saturate a cloth and wipe
the oven when it is cold; wipe dry with a clean
cloth.
WARNING!!
DO NOT spray the outside of the appliance
with water or clean with a water jet.
PREVENTIVE MAINTENANCE
The best preventive maintenance measures are
the proper initial installation of the equipment and
a program for cleaning the oven routinely. The
Oven/Steamer requires no lubrication. Contact
the factory, the factory representative or a local
Blodgett Combi service company to perform
maintenance and repairs should they be required.
WARNING!!
Always disconnect the power supply be-
fore servicing or cleaning the unit.
24