Center Display During A Workout - Precor C932i Owner's Manual

Standard commercial treadmill
Hide thumbs Also See for C932i:
Table of Contents

Advertisement

C
O
M
M
E
R
C
Table continued...
If QUICKSTART is pressed at the:
Weight prompt
Age prompt

CENTER DISPLAY DURING A WORKOUT

The PRECOR banner, setup prompts, program profiles and feature selections
appear in the center display. Prior to working out, prompts guide the user through
the Setup mode. Refer to Setup Mode and Prompts .
Once a user begins a workout, the SCAN LED is lit indicating that all highlighted
features (PROFILE, TIME, DISTANCE, etc.) will appear consecutively on the
display. A user can change what features are scanned by pressing the SELECT
key. Refer to Changing the Display Features Using the SELECT Key on page 35.
The following describes the information that can appear in the display.
PROFILE: At the beginning of a program, the profile appears on the right side of
the display and corresponds to the program that has been selected. As a user
proceeds through the workout, a blinking column indicates his or her position in
the program. The height of the column indicates the level of incline. Every time
the incline changes by several sequential levels (up or down) the height of the
column changes by one cell.
TIME: A time (0:00) display appears when a user begins working out. TIME ap-
pears in minutes and seconds. However, should a user exceed 60 minutes (dur-
ing a single workout), the TIME display converts to hours and minutes. Most
often, the TIME display shows the amount of time remaining in a workout.
DISTANCE: The distance that a user has traveled appears (00.00) once a work-
out begins. Distance can appear in miles or kilometers. If the user wishes to
change the display, they will need to contact the club manager or owner. Refer to
the instructions found in Club Information on page 21.
page 30
I
A
L
P
R
O
D
The following occurs:
The weight (150LB or 68KG) that appears
on the display becomes the designated weight
that the C932i uses to compute various cal-
culations. A user can change the display from
1 through 999 using the ▼ or ▲ keys.
The age prompt (AGE 0) that appears on
the display becomes the designated age that
the C932i uses for SmartRate
correct age entry between 1 and 99 is very
important if a user plans to use the heart
rate characteristics of the treadmill. The
QUICKSTART key acts the same as the
SELECT key at this point because the user
has answered all the Setup prompts.
U
C
T
S
D
I
V
I
S
I
O
N
system. A
®

Advertisement

Table of Contents
loading

Table of Contents