Power Connector Cable - HP ENVY 17 Maintenance And Service Manual

Power connector cable

Description
For use only on computer models equipped with a graphics subsystem with discrete memory
For use only on computer models equipped with a graphics subsystem with UMA memory
Before removing the power connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the display panel (see
5.
Remove the service cover (see
6.
Remove the hard drive (see
7.
Remove the memory modules (see
8.
Remove the WLAN module (see
9.
Remove the optical drive (see
10.
Remove the base enclosure (see
Remove the power connector cable:
1. Release the metal clip to disconnect the power connector cable (1) from the system board.
2. Disengage the cable from the clips (2).
84 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Display panel on page
Service cover on page
Hard drive on page 48).
Memory modules on page
WLAN module on page
Optical drive on page
Base enclosure on page
59).
47).
51).
52).
55).
64).
Spare part number
720240-001
720241-001