Optical Drive Connector Board - HP ENVY 17 Maintenance And Service Manual

Remove the front speakers:
1.
Turn the computer, with the front edge toward you.
2. Remove 4 screws (1).
3. Disengage the cables, and then remove the front speakers (2).
Reverse this procedure to install the speakers.

Optical drive connector board

NOTE: The optical drive connector board and cable are included in the optical drive spare part kit.
See x for optical drive spare part kit information.
Before removing the optical drive connector board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the service cover (see
6.
Remove the hard drive (see
Battery on page 46).
Service cover on page
Hard drive on page
47).
48).
Component replacement procedures
69