HP ENVY 17 Maintenance And Service Manual page 93

6.
Remove the hard drive (see
7.
Remove the memory modules (see
8.
Remove the WLAN module (see
9.
Remove the optical drive (see
10.
Remove the base enclosure (see
11. Remove the USB board (see
12. Remove the fingerprint reader module (see
Remove the Leap Motion module:
1. Disconnect the Leap Motion module cable (1) from the system board.
2. Remove the two Phillips PM1.5×2.5 screws (2) that secure the Leap Motion module to the top
cover.
3. Detach the Leap Motion module grounding shield (3) from the top cover. (The Leap Motion
grounding shield is attached to the top cover with double-sided adhesive.)
4. Remove the Leap Motion module (4).
Reverse this procedure to install the Leap Motion module.
Hard drive on page 48).
Memory modules on page
WLAN module on page
Optical drive on page
Base enclosure on page
USB board on page 79).
Fingerprint reader board on page
51).
52).
55).
64).
Component replacement procedures
81).
83