Sfp-Module Ports; Verify Port Connectivity - Cisco IE 3010 Getting Started Manual

Cisco IE 3010 Switch Getting Started Guide

SFP-Module Ports

Step 1
Grasp the module on the sides, and insert it
into the switch slot until you feel the
connector snap into place.
Step 2 Connect an appropriate cable to the module
port. Insert the other cable end into the other
device.

Verify Port Connectivity

78-19582-02
For a list of supported modules, see the release notes on Cisco.com. For detailed
instructions on installing, removing, and connecting to SFP modules, see the SFP
module documentation.
After you connect the switch port and another device, the port LED turns amber
while the switch establishes a link. This process takes about 30 seconds, and then
the LED turns green. If the LED turns off, the target device might not be turned
on, there might be a cable problem, or there might be a problem with the adapter
in the target device.
Cisco IE 3010 Switch Getting Started Guide
C i sc o IE
30 10
C i sc o IE
30 10
23