Lantronix Com Port Redirector User Manual page 18

10. Click the Com Setup button. A Port Setup dialog box similar to the one in
Figure 3-7 appears, with the first logical communications port checked.
The physical communication ports on the computer where Com Port
Redirector is installed are displayed as gray and unavailable. In Figure 3-7,
these are Com1 through Com3. Your unavailable communication ports may
vary from those in Figure 3-7.
11. Click all the logical ports to which the PC will be redirected. A checkmark
appears next to each logical port selected. Each port selected will be
available from the Redirect To drop-down list in the Com Port Redirector
Configuration window (this procedure is described in the next chapter).
12. To deselect a port, click it again to remove the checkmark next to it.
Removing the checkmark indicates the port will not be available from the
Redirect To drop-down list.
13. When finished, click OK.
Note: After you use the Port Setup dialog box to add or remove com
ports, reboot your computer.
3-6
Figure 3-7. Port Setup Dialog Box
Com Port Redirector™
User Guide