Networks & Services; Networks & Services > Network Configuration - Multitech MultiModem rCell MTCBA-H-EN2 User Manual

Networks & Services
Networks & Services > Network Configuration
Networks or Hosts can be added here. The options to Delete or Edit a network after it has been defined and added are
available by using the table at the bottom of the screen.
Network Configuration
Enter the Name, IP Address, and Mask for a new Network or Host.
Notes:
● A Network/Host Name cannot be edited.
● A Network/Host cannot be deleted if it is used in another configuration.
● Network/Host changes are reflected in all the configurations in the Web Management software where they are
used.
● A Network/Host added here will be displayed in the following sections: Static Routes, DNAT, and Packet Filters.
Name:
IP Address:
Subnet Mask:
Add Button:
Multi-Tech Systems, Inc. MultiModem rCell User Guide
Enter the name of the Network/Host. The same address-mask pair should not already be present
in the displayed list. The Name is limited to 15 characters maximum.
Enter the IP Address of the Network/Host. The same address-mask pair should not already be
present in the displayed list.
Enter the Network Mask of the Network/Host. For Host addresses, the mask is entered as 32.
See Appendix A -- Table of Commonly Supported Subnets.
Note:
Click the Add button. The defined network is added and will display at the bottom of the screen.
Chapter 3 – Using the Web Management Software
35