Air Cleaner; Air Cleaner Components; Breather Tube; Air Cooling - Kohler Command PRO CV940 Service Manual

Air Cleaner/Intake

AIR CLEANER

These systems are CARB/EPA certifi ed and components
should not be altered or modifi ed in any way.

Air Cleaner Components

C
B
E
Air Cleaner Housing
A
Element
C
Ejector Area
E
Retaining Clip
G
NOTE: Operating engine with loose or damaged air
cleaner components could cause premature
wear and failure. Replace all bent or damaged
components.
NOTE: Paper element cannot be blown out with
compressed air.
20
G
D
F
A
H
End Cap
B
Inner Element
D
Inlet Screen
F
Filter Minder
H
KohlerEngines.com
1. Unhook retaining clips and remove end cap(s).
2. Check and clean inlet screen (if equipped).
3. Pull air cleaner element out of housing and replace.
Check condition of inner element; replace when
dirty.
4. Check all parts for wear, cracks, or damage, and that
ejector area is clean.
5. Install new element(s).
6. Reinstall end cap(s) with dust ejector valve/screen
down; secure with retaining clips.

BREATHER TUBE

Ensure both ends of breather tube are properly
connected.

AIR COOLING

Hot Parts can cause severe burns.
Do not touch engine while operating or just
after stopping.
Never operate engine with heat shields or guards
removed.
Proper cooling is essential. To prevent over heating,
clean screens, cooling fi ns, and other external surfaces
of engine. Avoid spraying water at wiring harness or any
electrical components. Refer to Maintenance Schedule.
WARNING
62 690 02 Rev. D