Display Of Stored Min/Max Values And Alarm Value Settings - La Crosse Technology WS-3500 Operation Manual

Relearn Mode (Relearn Tx) → Allows to newly recognize the outdoor
transmitter (e. g. after a battery change in the transmitter) without the
necessity of a comprehensive re-setup of all system components →
Acknowledge with ‫٭‬CONFIRM‫.٭‬
Default Settings (Factory Reset) → Allows to clear all weather data
form non-volatile buffer memory (EEPROM) and reset of all set and/or
stored values to the factory settings set prior to shipment →
Acknowledge with ‫٭‬CONFIRM‫.٭‬
Note:
It will take about 5 minutes for the factory reset process. During this
period, the text "Factory Reset In Progress" will be shown. After the
reset process is finished, the LCD will switch off and the text "Remove
Battery" will be displayed. Remove the battery and perform system
start again. See "3 - Putting in Operation" paragraph.
Leaving the basic settings procedure (Setup Mode) with ‫٭‬EXIT‫.٭‬
5 Display of stored Min/Max Values and Alarm Value
Settings
Named values are in each case upon recall being simultaneously
displayed and flashing in their respective display sections.
To recall named measuring and alarm values the menu shown below
will have to be activated by touching the Touch Screen in the center of
39