Table of Contents
Advertisement
Default Settings (Factory Reset) → Allows clearing of all weather
data in non-volatile buffer memory (EEPROM) and to reset of all set
and/or stored values to the factory settings set prior to shipment →
Acknowledge with ٭CONFIRM.٭
Note:
It will take 5 minutes for the factory reset process. During this period,
the text "Factory Reset In Progress" will be shown. After the reset
process is finished, the LCD will switch off and the text "Remove
Battery" will be displayed. Remove the battery and perform system
start again. See "3 - Putting in Operation" paragraph.
To leave the basic settings procedure (Setup Mode) touch ٭EXIT.٭
5
Display of Stored MIN/MAX Alarm Value
Settings
Named values are in each case upon recall being simultaneously
displayed and flashing in their respective display sections.
To recall measuring and alarm values, the menu shown below will
have to be activated by touching the Touch Screen in the center of the
text display section (last 2 lines at the bottom of the LCD). The display
of the values is started by touching the displays ٭MINMAX ٭or
٭ALARMS.٭
All manuals and user guides at all-guides.com
15
Advertisement
Table of Contents
