Installation; Connecting; Ac Connections; Ac Power Connection - McIntosh MX 110 Owner's Manual

The MX 110 can be installed in conventional
furniture cabinets, custom built installations
or professional relay racks. If the unit is to be
placed on a shelf or table-top, it is recom-
mended that it be housed in a Mclntosh
cabinet. Install the MX110 from the front of
the cabinet, not from the rear.
To support the weight of the MX110, the
wood panel used to mount it should be at
least ¼ inch thick.

AC CONNECTIONS

There are three AC outlets on the rear
panel of the MX110. (See Figure 17.1 These
receptacles have a maximum rating of 350
watts total. The power to the two black
receptacles is controlled by the POWER
switch on the front panel. The red receptacle
is not switched. The red receptacle is used
for powering a turntable or record changer.
The receptacle is not switched so that the
turntable power will not be turned off while
10

INSTALLATION

The MX 110 installation should allow l3½
inches behind the front panel which includes
1½ inches for connectors. The desirable
width and height of the installation
inches and a minimum of 5½ inches, re-
spectively, so that sufficient space is allowed
for the circulation of air. These are inside
dimensions. The front panel mounting space
width and height are 16
inches, respectively. Allow at least 1½ inches
for knob clearance in a custom built installa-
tion.

CONNECTING

the turntable idler wheel
turntable is protected by this arrangement
because it is necessary to turn off the turn-
table with its own control switch so that no
damage will result to the drive system.
AC POWER
Plug the AC power cord in 105 volt to 125
volt, 50 to 60 cycle power line. The power
used by the MX110 is 75 watts.
Figure 17. AC Connections.
are 16
3
inches and 5 /
8
engaged. The