Table of Contents
Advertisement
Installation
The MI1250 needs to be placed upright on its four feet.
It also can be custom installed. Remove the four feet
when it is custom installed and retain them with the
fastening screws for possible future use. The required
panel cutout, ventilation cutout and unit dimensions are
shown in the drawing on the right side of this page.
It is necessary to provide adequate ventilation for cool
operation, ensuring long life for the unit. Do not install
the MI1250 above heat generating components. When
installed in a cabinet with other components, use a
ventilation fan to provide cool operating temperature.
A custom cabinet installation needs to provide the
minimum spacing for cool operation; be sure to cut out
a ventilation hole in the mounting shelf according to the
dimensions in the drawing to the right.
Note: When the MI1250 is installed together with
other McIntosh Components, check clearances
on all components before proceeding.
Installation of Side Rack Mount Brackets
When desired, to install MI1250 Side Rack Mounting
Brackets, follow the steps below for one side at a time:
1. Refer to figure A to remove the two side screws and
save them for possible future use.
2. Position the Side Rack Mounting Bracket as illustrated
in figure B. Then attach the Bracket to the Front and
Side Panel of the MI1250, using the screws supplied
with the Bracket.
3. Perform steps 1 and 2 to mount the second Bracket to
the other side of the MI1250.
4
MI1250 Front Panel
Custom Cabinet Cutout
Cabinet
Front
Panel
Opening
for Ventilation
MI1250 Side View
in Custom Cabinet
Support
Shelf
"
29/32
2.4cm
MI1250 Bottom View
in Custom Cabinet
Note: Center the cutout Horizontally
on the unit. For purposes of
clarity, the above illustration
is not drawn to scale.
3"
7.6cm
Front Panel
Side Panel
Remove two
Screws from
the Chassis
Sidewall
and save
Figure A
them
16-
"
7/8
42.8cm
3"
Cutout Opening for Custom Mounting
7.6cm
Cutout Opening for Custom Mounting
Cutout Opening for Ventilation
"
25/32
2.0cm
10-
"
9/16
26.9cm
14-
"
7/16
Cutout Opening
36.2cm
for Ventilation
11-
"
19/32
29.7cm
Front Panel
Side Rack
Mounting
Bracket
Supplied
Screws
3-
"
1/4
8.2cm
Chassis
Spacers
15"
38.1cm
Side Panel
Supplied
Screws
Figure B
Advertisement
Table of Contents
