Listening To Stereo Tape Machine - McIntosh MX 110 Owner's Manual

7. Set the BASS controls and TREBLE
controls so that the dial indicator is centered
between the panel markings • L and ° R.
8. Adjust the VOLUME control to the
desired volume.
LISTENING TO A STEREO TAPE MACHINE
A stereo tape machine with its own play-
back preamplifiers should be plugged into
the AUX input or the TAPE MONITOR input
—not the TAPE HEAD input.
If the AUX input is used, proceed as
follows:
1. Turn the INPUT SELECTOR to AUX.
2. Set the MODE SELECTOR to MONO
(L+R) or STEREO depending on the program
on the tape.
3. Set the PHASE switch to 0°.
4. Set the HF cutoff filter to OUT. (See
page 00 ADJUSTING FOR SPECIAL EFFECTS.)
5. Place the LF rumble filter control in the
OUT position. (See page 15 ADJUSTING FOR
SPECIAL EFFECTS.)
6. Set the LOUD control to OUT. (See
page 00 ADJUSTING FOR SPECIAL EFFECTS.)
7. Set the BASS control and TREBLE con-
trols so that the dial indicator is centered
between the panel markings • L and ° R.
8. Adjust the VOLUME control to the de-
sired volume.
If the TAPE MONITOR input is used pro-
ceed as follows:
1. Push the TAPE MONITOR switch to IN.
2. Set the MODE SELECTOR switch to
MONO (L+R).
3. Set the PHASE switch to 0°.
4. Set the HF cutoff filter to OUT. (See
page 15 ADJUSTING FOR SPECIAL EFFECTS.)
5. Place the LF rumble filter control in the
OUT position. (See page 15 ADJUSTING
FOR SPECIAL EFFECTS.)
6. Set the LOUD control to OUT. (See page
15 ADJUSTING FOR SPECIAL EFFECTS.)
7. Set the BASS controls and TREBLE
controls so that the dial indicator is centered
between the panel markings * L and ° R.
8. Adjust the VOLUME control to the
desired volume.
17