10. Use the threaded end of the fluid needle (21) to
push out the u-cup seal (33). See Fig. 33.
21
Fig. 33
12
19
47
1
20
1
17
4
1
1
Lightly lubricate
Lightly lubricate threads
2
3
Lightly lubricate contact area on trigger face
4
Apply part no. 514–767 Form-A-Gasket Sealant to the front area
of the gun where the baffle sits and to the baffle protrusion. Insert
the baffle protrusion into the gun insert hole.
Fig. 34
Service
02760
49m
49p
49j
49q
49h
53
3
48
51
4
11
52
3
39
1
31
1
11. Remove and disassemble the activator valve (49).
See Fig. 34. Use the threaded end of the activator
needle (49d) to push out the needle packings (49g
and 49r). Do not bend the end of the needle.
12. Clean the parts. Check the fluid needles (21 and
49d) for damage or excessive wear. Replace if
necessary.
13. Check the baffle (11) for damage. If it is damaged,
carefully pry it off with a screwdriver and replace it.
Apply part no. 514–767 Form-A-Gasket Sealant to
the front area of the gun where the baffle sits and
to the baffle protrusion. Insert the baffle protrusion
into the gun insert hole.
14. Lightly lubricate the parts indicated in Fig. 34 with
Part No. 111–265 lubricant.
1
49f
49r
49g
49b
49
52
55
49e
1
2
49e
1
5
33
14
1
15
1
16
32
1
49d
49e
49c
49a
49k
21
1
22
6
8
2
05885