Sound Active Mode; Master/Slave Configuration - ADJ UV Cob Cannon User Instructions

UV COB Cannon
UV Manual Dimmer Mode:
1. Plug the fixture in and press the MODE button until:
2. When "XXX4" is displayed you are in dimming mode.
Press the UP and DOWN buttons to adjust intensity.
3. When "XXX5" is displayed you are in strobing mode.
Press the UP and DOWN buttons to adjust strobing.
4. When "XXX6" is displayed you are in dimmer curve adjustment.
Press the UP and DOWN buttons to scroll through the different
curve modes. See the dimmer curve chart on page 11.

Sound Active Mode:

In this mode the UV COB Cannon will react to sound, and chase
through the different colors.
1. Plug the fixture in and press the MODE button until "0017" is dis-
played.
2. The fixture will now change via sound.
3. Press the UP or DOWN button so that "0027" is displayed. This is
sound sensitivity adjustment. Use the UP and DOWN buttons to
adjust the sensitivity.
ADJ Products, LLC - www.adj.com - UV COB Cannon - User Manual Page 8
Operating Instructions UV COB Cannon
Master-Slave Configuration:
This function will allows you to link units together to run in a Master-Slave
mode. In Master-Slave operation one unit will act as the controlling unit
and the others will react to the controlling units built-in programs. Any
unit can act as a Master or as a Slave however, only one unit can be pro-
grammed to act as the "Master."
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit.
Use standard XLR data cables to link your units together. Remember
that the Male XLR connector is the input and the Female XLR con-
nector is the ouput. The first unit in the chain (master) will use the
female XLR connector only. The last unit in the chain will use the
male XLR connector only.
2. On the "Master" unit, press the MODE button until "0018" is dis-
played. This is the "Master" setting, press the SAVE button. After you
have set it to the "Master" setting, set your desired operating mode.
3. For the "Slave" unit, press the UP or DOWN button so that "0028" is
displayed. This is the "Slave" setting, press the SAVE button.
4. Now connect the "Slave" unit to the "Master" unit using the XLR con-
nections.
ADJ Products, LLC - www.adj.com - UV COB Cannon - User Manual Page 9
Master-Slave Configuration