Motor Replacement; Removal; Installation - Graco 311365G Repair Manual

Removal

Relieve pressure; page 9.
1. Remove pump (91); see Displacement
Pump Replacement, page 34 (695/795)
page 36 (1095/1595/Mark V).
CAUTION
Do not drop gear cluster (89) when removing
drive housing (90). Gear cluster may stay
engaged in motor front end bell or drive
housing.
2. Remove drive housing (90); see Drive
Housing Replacement, page 30.
3. Remove shroud (58).
4. Remove four screws (38) and control cover
(96).
5. Remove bottom two screws (39) and allow
control panel (68) to hang down freely.
6. Disconnect all three motor connectors from
motor control board (52).
7. Disconnect motor leads.
8. Remove top two screws (39) and control
housing (61).
9. Remove strain relief (29) from motor wires
and power bar plate (69).
10. Remove motor wires from baffle 278075
and remove baffle.
32

Motor Replacement

11. Remove two screws (23) and nuts (19) on
12. Loosen two nuts (19) on side near control

Installation

1. Slide new motor (84) under two screws (23)
2. Install two screws (23) and nuts (19) on
3. Install baffle and connect motor wires.
4. Tighten all four screws (23) and nuts (19).
5. Install strain relief (29) onto motor wires
6. Install control housing (61) with top two
7. Connect motor leads.
8. Connect all three motor connectors to
9. Install control panel (68) with two screws
10. Install control cover (96) with four screws
11. Install drive housing (90); see Drive
12. Install pump (91); see Displacement
side opposite control.
and remove motor (84) from cart frame
(62).
in cart frame (62) near control.
motor side opposite control.
torque nuts to 115-135 in-lb (13-15 N•m).
and into power bar plate (69).
screws (39).
motor control board (52).
(39).
(38).
Housing Replacement, page 30.
Pump Replacement, page 34 (695/795)
page 36 (1095/1595/Mark V).
Motor Replacement
311365G