Operation - TANDBERG 880 MXP User Manual

MBTelehealth – Tandberg 880 MXP User Guide

12.2 Operation

To operate the patient camera:
1.
Connect the patient camera to your video conference equipment following the
instructions listed above.
2.
Ensure the power is turned on by looking for the green power indicator light on
the top of the camera. If the power light is on but there is no display on the
viewfinder, the camera is in sleep mode. Press the power button to reactivate
the display.
3.
For optimal images, there should be adequate lighting in the room and the
onboard light (#3 in the Parts of the n_sight Patient Camera diagram) should be
turned off. Press the light button on the camera to turn the light on and off.
4.
Point the patient camera at the subject or image and use the zoom in and out
button to focus on the object. The camera will automatically refocus as you
zoom in and out.
5.
If a still image is required, zoom in and out until you have the appropriate image
in view then press the image capture button to freeze the image. Press it again
to unfreeze the image and return to normal viewing.
Image Capture Button
6.
Once completed, turn off the Power by pressing and holding the power button,
then plug the camera in to recharge the batteries.
Rear View of Patient Camera
Top View of Camera
Page 24 of 31
Zoom In/Out
Light On/Off