Hanging Installation Instructions; Sediment Trap Assembly Instructions - L.B. White 377 Owner's Manual And Installation Instructions

1. Assemble according to the illustration and tighten all
eyebolts securely. (See Fig. 2):
FIG. 2
EYEBOLT
NUT
FLAT WASHER
CAGE NUT
2. Be sure heater is securely fastened and is hanging
level. (Check crosswise and lengthwise.)
3. See Fig. 3 for typical indoor installation. In any animal
confinement building, consideration must be given to
making sure the heater is located away from the
livestock so that livestock cannot knock the heater,
tear it loose from its mounting, or damage the heater
or its gas supply line in any way. Make sure you
observe and obey minimum clearance distances to
combustible materials as stated in the specification
section of this owner's manual and on the heater
itself.
Optional Accessory
Assemble the tee, nipples and cap together and tighten
securely. See Fig. 4. The sediment trap assembly must
always be mounted in a vertical position. Make sure pipe
thread compound that is resistant to both propane gas and
natural gas is used in making all connections. Check a a ll
connections f f or g g as l l eaks u u sing a a pproved g g as l l eak
detectors.
FIG. 3
NOTE: REGULATORS SHOULD ALWAYS BE MOUNTED OUTDOORS. IF
CIRCUMSTANCES FORCE INSTALLING THE REGULATOR INDOORS,
THE REGULATOR'S VENT MUST BE VENTED OUTDOORS USING VENT
LINE NO SMALLER THAN VENT OPENING.
VENT OF REGULATOR MUST
POINT DOWN AND REGULATOR
CHAIN
MUST BE VENTED OUTDOORS
CASE TOP
OPTIONAL INDOOR
REGULATOR
MOUNTING LOCATION
AIR DIVERTER
AIR DIVERTER
FIG. 4
TO GAS CONTROL
VALVE INLET
HANGING INSTRUCTIONS
GAS HOSE
THERMOSTAT
CORD
HEATER
30.5CM
1 FT.
THERMOSTAT
SEE SPEC.
30.5CM
SEDIMENT TRAP ASSEMBLY
NIPPLE
MANUAL SHUT-OFF VALVE
CAN BE INSTALLED BEFORE
THE REGULATOR, UNDER
THE EAVE OF THE BUILDING,
OR AFTER THE REGULATOR
INSIDE THE BUILDING.
BLACK PIPE
THROUGH WALL
VENT LINE
WALL OUTLET
POWER CORD
SEDIMENT
TRAP
TABLE
HOSE ADAPTER
TEE
NIPPLE
CAP
9