Replacing Wheels; When To Replace Your Wheels; Wheel Selection - Toyota Tacoma 2002 Operating Manual

CAUTION
D
Do not exceed 50 km/h (30 mph) or
the chain manufacturer's
mended speed limit, whichever is
lower.
D
Drive carefully avoiding
holes, and sharp turns, which may
cause the vehicle to bounce.
D
Avoid sharp turns or locked–wheel
braking, as use of chains may ad-
versely affect vehicle handling.
D
When driving with chains installed,
be sure to drive carefully. Slow
down before entering the curves to
avoid losing control of the vehicle.
Otherwise an accident may occur.
NOTICE
Two–wheel drive model
P235/55R16 size tire:
Due to a lack of wheel clearance, do
not use tire chains as they can dam-
age your vehicle.
268

Replacing wheels

WHEN TO REPLACE YOUR WHEELS

If you have wheel damage such as
bending, cracks or heavy corrosion, the
wheel should be replaced.
recom-
If you fail to replace damaged wheels, the
tire may slip off the wheel or cause loss
of handling control.
bumps,

WHEEL SELECTION

When replacing wheels, care should be
taken to ensure that the wheels are re-
placed by ones with the same load ca-
pacity, diameter, rim width, and offset.
Correct replacement wheels are available
at your Toyota dealer.
A wheel of a different size or type may
adversely affect handling, wheel and bear-
ing life, brake cooling, speedometer/odom-
eter calibration, stopping ability, headlight
aim, bumper height, vehicle ground clear-
ance, and tire or snow chain clearance to
the body and chassis.
with
2002 MY TACOMA_U (OM35786U)
'02 Tacoma U (L/O 0109)
Replacement with used wheels is not rec-
ommended as they may have been sub-
jected to rough treatment or high mileage
and could fail without warning. Also, bent
wheels which have been straightened may
have structural
should not be used. Never use an inner
tube in a leaking wheel which is designed
for a tubeless tire.
damage and therefore