Toyota Tacoma 2002 Operating Manual page 133

(c) Shifting procedure
(lever/button type with manual
transmission)
SHIFTING BETWEEN "H2" AND "H4"
To shift from "H2" to "H4", reduce your
speed to less than 100 km/h (62 mph)
and push in the "4WD" button. You need
not depress the clutch pedal.
If the indicator light does not come on
when you push in the "4WD" button, drive
straight ahead while accelerating or decel-
erating.
If the indicator light flashes and the buzz-
er sounds when you push in the "4WD"
button, reduce your speed or stop the
vehicle and reset.
CAUTION
Never push the "4WD" button
wheels are slipping. Stop the slipping
or spinning before shifting.
To shift from "H4" to "H2", push the
"4WD" button again to turn it off.
This can be done at any vehicle speed.
You need not depress the clutch pedal.
If the indicator light does not go off when
you shift the transfer into "H2", drive
straight ahead while accelerating or decel-
erating, or drive in reverse.
'02 Tacoma U (L/O 0109)
SHIFTING BETWEEN "H2" OR "H4" AND
"L4"
To shift from "H2" or "H4" to "L4",
stop the vehicle or reduce your speed to
less than 8 km/h (5 mph). With your foot
off the accelerator pedal, depress the
clutch pedal and move the front drive con-
trol lever.
To shift from "L4" to "H2" or "H4",
depress the clutch pedal and move the
front drive control lever. When the "4WD"
button is pushed in, the transfer shifts into
"H4"; when the button is left out, the
transfer shifts into "H2".
This can be done at any vehicle speed.
If the indicator light does not go off when
if
you shift the transfer into "H2", drive
straight ahead while accelerating or decel-
erating, or drive in reverse.
2002 MY TACOMA_U (OM35786U)
(c) Shifting procedure
(lever/button type with
automatic transmission)
SHIFTING BETWEEN "H2" AND "H4"
To shift from "H2" to "H4", reduce your
speed to less than 100 km/h (62 mph)
and push in the "4WD" button.
If the indicator light does not come on
when you push in the "4WD" button, drive
straight ahead while accelerating or decel-
erating.
If the indicator light flashes and the buzz-
er sounds when you push in the "4WD"
button, reduce your speed or stop the
vehicle and reset.
CAUTION
Never push the "4WD" button
wheels are slipping. Stop the slipping
or spinning before shifting.
To shift from "H4" to "H2", push the
"4WD" button again to turn it off.
This can be done at any vehicle speed.
If the indicator light does not go off when
you shift the transfer into "H2", drive
straight ahead while accelerating or decel-
erating, or drive in reverse.
if
133