Floor Mat; Installing Front License Plate - Toyota Tacoma 2002 Operating Manual

Floor mat

Use a floor mat of the correct size.
If the floor carpet and floor mat have a
hole, then it is designed for use with a
locking clip. Fix the floor mat with locking
clip into the hole in the floor carpet.
'02 Tacoma U (L/O 0109)
CAUTION
Make sure the floor mat is properly
placed on the floor carpet. If the floor
mat slips and interferes with
movement of the pedals during driv-
ing, it may cause an accident.
2002 MY TACOMA_U (OM35786U)

Installing front license plate

(four–wheel drive models and
Pre Runner)
Valance panel
Shorter
tapping screws
Front license plate
Install the front license plate using the
following procedure:
1. Remove and discard the front license
plate frame (if installed on the vehicle
at delivery).
the
2. Align the holes on the front license
plate with the dimples on the valance
panel.
3. Install the two longer tapping screws
through the upper holes, and the two
shorter tapping screws through the low-
er holes of the license plate, into the
dimples on the valance panel.
Do not drill holes in the dimples on the
valance panel.
Longer
tapping screws
185