Toyota Tacoma 2002 Operating Manual page 131

(a) Front drive control
(lever/button type)
Use the front drive control lever and
"4WD" button to select the following
transfer modes.
"H2" (high speed position, two–wheel
drive): Lever at "H", "4WD" button left out
Use this for normal driving on dry hard–
surfaced roads. This position gives greater
economy, quietest ride and least wear.
"H4" (high speed position, four–wheel
drive): Lever at "H", "4WD" button pushed
in.
Use this for normal driving on wet, icy or
snow–covered roads. This position pro-
vides greater traction than two–wheel
drive.
'02 Tacoma U (L/O 0109)
"N" (neutral position): Lever at "N"
No power is delivered to the wheels. The
vehicle must be stopped.
"L4" (low speed position, four–wheel
drive): Lever at "L4"
Use this for maximum power and traction.
Use "L4" for climbing or descending steep
hills, off–road driving, and hard pulling in
sand, mud or deep snow.
The four–wheel drive indicator light comes
on when the "H4", "N" or "L4" mode is
selected.
See "(c) Shifting procedure (lever/button
type)" for further instructions.
2002 MY TACOMA_U (OM35786U)
(b) A.D.D. (automatic
disconnecting differential)
The A.D.D. can be engaged or disen-
gaged by the shifting operations de-
scribed in "(c) Shifting procedure".
You should drive in four–wheel drive for
at least 16 km (10 miles) each month.
This will assure that the front drive com-
ponents are lubricated.
131