Manual Configuration - Ericsson HM220d User Manual

5.3

Manual configuration

Manual configuration is used if you have not been provided with any auto configuration
strings. The following pictures will guide you through the wizard and explain the settings.
Select the operating mode
Figur 41: Configuration wizard - Select operating mode
Operating mode
ADSL modems operate in one of several modes determined by the DSLAM (equipment
at the ISP side of the ADSL line), central office setup and also by the service offered. The
HM220d ADSL modem can be configured to operate in three different modes:
Routed/PPPoA (default), Routed/RFC1483 or Bridged/RFC1483. Which one you need
to use depends on the configuration specified by your ISP/service provider.
ADSL mode
The HM220dp modem can work in four different ADSL modes: Multimode (default),
T1.413, G.Dmt and G.Lite. The HM220di model can work in two ADSL modes: G.Dmt
and DTAG. The ADSL-mode depends on what services you are offered and your
ISP/service provider must provide this information.
Modem IP address and Subnet mask
These IP addresses belongs to the modem itself and have factory default values. They can
be changed if they are not suitable in your LAN.
Make customized settings
If the "Make customized settings?" checkbox is ticked, a page with optional settings will
appear later on in the wizard. These settings are not required to be set for operation of the
modem.
Enter your settings and click on Next.
42 (87)
Configuring the modem
EN/LZT1083982 R4
2000-12-07