Connecting Equipment - Ericsson HM220d User Manual

2.2

Connecting equipment

To connect your HM220d ADSL modem via the Ethernet interface, follow these steps:
1 Connect one end of the Telephone/ADSL cable to the modem's ADSL port and the
other end to the ADSL service port (wall jack or splitter/filter).
2 Connect one end of the Ethernet cable to the ETHERNET port on the back of the
modem and connect the other end to the Ethernet 10Base-T network card on your
computer.
3 Connect the Power cable to the POWER connector on the back of the modem. Plug
the power supply adapter into a power source.
Figur 1: Connect via Ethernet interface
Assuming the modem has been connected properly, the modem will enter the power-up
diagnostics state and verify the integrity of the hardware and software. Please refer to
chapter 6.3 Operational states, for further information. When this happens all of the LEDs
(light-emitting diodes) on top of the modem will turn ON briefly.
When the Power, Ethernet and ADSL LEDs have turned solid yellow, the modem is
ready for operation.
Figur 2: LED symbols for Power, Ethernet and ADSL
If not, check that the cables have been securely connected to both the modem, PC, ADSL
service port and power source.
EN/LZT1083982 R4
2000-12-07
Installation using Ethernet (for Windows 95 or higher PCs)
11 (87)