Wall Mounting Instructions; Filter Installation - Ericsson HM220d User Manual

Pick a location for the HM220d ADSL modem that:
enables you to view the LEDs on top of the modem
allows you to reach and press the PipeLock button on top of the modem
is close to a power outlet, phone jack, and the computer (PC) to facilitate connections
to these devices
does not restrict air flow around the modem
allows plenty of room for cables to be routed from the back of the modem without
crimping the cables
1.4.1

Wall mounting instructions

The modem is mounted to the wall using two screws and the two mounting slots on the
bottom of the unit.
Follow the step-by-step instructions below to mount the modem to the wall:
1 Insert and secure screws to the wall at a distance of 100 mm (3,9"). If needed, drill
holes and insert plastic anchors or toggles first.
The screws should not be secured flush to the wall. Leave a gap of approximately
1/4" from the wall surface to the bottom of the screw head.
2 Slip the HM220d ADSL modem slots over the screw heads and pull down until the
unit is seated securely. A slight adjustment to the screws may be necessary to provide
a snug fit to the wall.
1.5

Filter installation

To maintain normal phone service, a special filter may need to be installed at your home.
This filter, sometimes called a splitter, splits the voice (phone) signal from the ADSL
(data) signal.
Set-up and installation charges for ADSL service typically include the filter installation.
If you are not sure if a filter needs to be installed, contact your service provider.
EN/LZT1083982 R4
2000-12-07
Introduction
9 (87)