Local Pc Configuration; Configuring Pcs As Dhcp Clients; In Windows 95, 98/98Se And Me - Ericsson HM210DP/DI User Manual

Local PC Configuration

3 Local PC Configuration
By default, the HM210dp/di acts as a DHCP server that automatically
assigns all required Internet settings to your PCs, i.e. the DHCP clients.
The predefined IP address and DHCP range is as below:
LAN Port IP Address 192.168.1.1
Subnet Mask
DHCP Range
The following instructions assume that your PC meets the following
prerequisites:
You need only to configure the PCs to accept the information when it is
assigned. Follow the instructions that correspond to the operating system
installed on each PC.
3.1

Configuring PCs as DHCP Clients

If you have not been provided any IP settings from your ISP/service
provider, you should use DHCP that is the most common used method.
3.1.1

In Windows 95, 98/98SE and Me:

6
255.255.255.0
192.168.1.3 – 192.168.1.34
1. Already is connected to the LAN port on the HM210dp/di through its
network interface card (NIC).
2. Has the appropriate Ethernet adapter software installed.
3. Has the TCP/IP protocol installed. If not, refer to Microsoft
documentation to install the TCP/IP protocol.
1. From the Start menu select Settings > Control Panel and double-
click on the Network icon.
2. Click the Configuration tab and select TCP/IP for the network
adapter that is connected to your HM210dp/di. Click the Properties
button.
3. Select the IP Address tab and make sure that "Obtain an IP
address automatically" is selected. If not, select it and click OK.
4. Click OK in the "Network" dialog box and close the Control Panel.
EN/LZT 108 6492 R2 - October 2003