For Users Receiving Digital Broadcast Services - Pioneer RCS-656HX Operating Instructions Manual

Getting started
04
ENTER
11 Select the TV screen type, 'Wide (16:9)' or
'Standard (4:3)'.
k Setting TV Screen Size
t Line System
er Save
P
p Navigator p Navigator
ENTER
12 Select whether or not your TV is
compatible with progressive scan video.
k Setting Progressive
t Line System
er Save
P
p Navigator p Navigator
• Note that progressive scan video is only output
through the AV1(RGB)-TV connector and the
component video outputs.
13 Press to continue after reading the HDD
ENTER
caution.
k Setting In the event of HDD failure, recordings may
be lost or normal playback/recording may
t Line System
not be possible.
er Save
As recordings might be lost in case of a HDD
P
failure, we recommend to use the HDD only
as temporary storage media.
p Navigator p Navigator
Please copy recordings you want to keep
to recordable DVD.
Press ENTER to continue.
ENTER
14 Select 'Finish Setup' to exit the Setup
Navigator, or 'Go Back' if you want to start again.
k Setting
t Line System
er Save
p Navigator p Navigator
That completes basic setup using the Setup Navigator.
• If there are blank channels with no station, you can
set these to skip using the manual channel setting.
See Manual CH Setting on page 131.
58
En
Wide (16:9)
Standard (4:3)
Compatible
Not Compatible Not Compatible
Don't Know
S e t u p i s c o m p l e t e !
E n j o y u s i n g y o u r D V D r e c o r d e r !
F i n i s h S e t u p F i n i s h S e t u p
G o B a c k
For users receiving digital broadcast
services
This unit can set its internal clock automatically from
digital broadcasts. However, depending on the
broadcaster, the clock information received may not be
accurate.
Use the following procedure (while the recorder is not
recording) to set the clock manually.
1 HOME MENU Press HOME MENU.
ENTER
2 Select 'Initial Setup' > 'Basic' > 'Clock
Setting'.
3 Highlight the time setting.
4 Press ENTER to display the manual clock
ENTER
setting screen.
5 Set the correct time.
Return to automatic clock setting
• To return to the automatic clock setting, follow the
instructions for 'Replace Channels' (page 130).