Pioneer RCS-656HX Operating Instructions Manual page 137

The Initial Setup menu
Setting Options
HDMI Output
(only available when an HDMI device is connected)
Screen Resolution 1920 x 1080i
1280 x 720p
720 x 576p
720 x 480p
720 x 576i
720 x 480i
If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this case, press ONE TOUCH COPY
(STOP) button on the front panel to switch the setting (this also switches Component Video Out on page 132 to the
while holding down the
default setting).
4:3 Video Output Full
Normal
Colour RGB (0–255)
RGB (16–235)
YCbCr 4:2:2
YCbCr 4:4:4
• Depending on the connected device some settings may not be available.
• When a DVI device is connected, the YCbCr 4:2:2 and YCbCr 4:4:4 options are not available.
Audio Output Auto •
PCM
Bitstream Priority
This setting is not available when a DVI device is connected
Video Priority Mode HDMI •
Component
Options
On Screen Display On •
Off
Front Panel Display On •
Off
Explanation
Constant 1920 x 1080i output.
Constant 1280 x 720p output.
Constant 720 x 576p output (for use with the 625 input line system).
Constant 720 x 480p output (for use with the 525 input line system).
Constant 720 x 576i output (for use with the 625 input line system).
Constant 720 x 480i output (for use with the 525 input line system).
Select if your HDMI TV allows you to change the aspect ratio.
Select if your HDMI TV does not allow you to change the aspect ratio. 4:3
video will be shown with bars on each side (unless the Screen Resolution
setting (above) is set to 720 x 480i or 720 x 576i).
Use if colours are weak and black appears to 'float' on the RGB (16–235)
setting.
Use this setting if colours appear overly rich and the black too deep on the
RGB (0–255) setting.
The video signal is output as a 10-bit YCbCr 4:2:2 component signal. This is
the standard setting for HDMI-compatible devices.
The video signal is output as a 8-bit YCbCr 4:4:4 component signal.
Dolby Digital, MPEG and DTS sources are output as a bitstream signal.
However, depending on the Audio Out setting, number of audio chan-
nels, and the HDMI-connected device, Linear PCM audio may be output.
All audio signals are converted to Linear PCM (except DTS).
Select if the connected device is compatible with bitstream audio.
.
Select for high quality picture output on a connected HDMI display. How-
ever, on this setting the YNR and Detail picture quality settings are not
effective for analog video, and component video will be set to interlaced.
Select if you want the YNR and Detail picture quality settings to be
effective for both HDMI and analog video output, or if Component Video
Out is set to Progressive while an HDMI display is connected (page 132).
When watching video on an HDMI display, use the HDMI setting.
The recorder displays operation displays (Stop, Play, etc.) on-screen.
Switches off the on-screen operation displays.
The time is shown in the front panel display when the recorder is in standby.
The front panel display is switched off in standby (although it still lights
dimly when setting a timer recording).
16
137
En