Hints On Installation; Moving The Recorder; Resetting The Recorder - Pioneer RCS-656HX Operating Instructions Manual

Additional information

Hints on installation

We want you to enjoy using this unit for years to come, so
please bear in mind the following points when choosing
a suitable location for it:
Do...
Use in a well-ventilated room.
Place on a solid, flat, level surface, such as a table,
shelf or stereo rack.
Don't...
Use in a place exposed to high temperatures or
humidity, including near radiators and other heat-
generating appliances.
Place on a window sill or other place where the
recorder will be exposed to direct sunlight.
Use in a dusty or damp environment or in a room
where it will be exposed to excessive cigarette smoke.
Place directly on top of an amplifier, or other
component in your stereo system that becomes hot in
use.
Use near a television or monitor as you may
experience interference—especially if the television uses
an indoor antenna.
Use in a kitchen or other room where the recorder
may be exposed to smoke or steam.
Use on a thick rug or carpet, or cover with cloth—this
may prevent proper cooling of the unit.
Place on an unstable surface, or one that is not large
enough to support all four of the unit's feet.

Moving the recorder

If you need to move the recorder, first remove the disc, if
loaded, and close the disc tray. Next, press
to switch the power to standby, checking that the
POWER OFF indication in the display goes off. Wait at
least two minutes. Lastly, disconnect the power cord.
Never lift or move the unit during playback or recording—
discs rotate at a high speed and may be damaged.

Resetting the recorder

If you need to, you can reset the recorder to all its factory
settings.
1 Make sure that the recorder is on.
2 Using the front panel controls, press and hold
STOP and press STANDBY/ON.
The recorder turns off with all settings reset.
17
STANDBY/ON
153
En