Powerline P2 X Owner's Manual page 8

S T E P
1
Be careful to assemble all components in
the sequence they are presented.
A. Attach Stabilizing Leg (P) to the Lower Main Frame (A) as shown using:
One 98 (10mm x 110mm hex head bolt)
Two 101 (10mm washer)
Two 94 (pulley spacer)*
One 70 (10mm nylon lock nut)
*NOTE:
The Pulley Spacers fit into the Lower Main Frame. You will be installing a pulley in Step 11,
so please only finger tighten hardware.
B. Attach Lower Main Frame (A) to Rear Leg (B) and Rear Upright (C) using:
Two 55 (10mm x 65mm hex head bolt)
Two 70 (10mm nylon lock nut)
C. Attach Upper Main Frame (D) to Lower Main Frame (A) using:
Two 98 (10mm x 110mm hex head bolt)
Four 60 (10mm washer)
Two 70 (10mm nylon lock nut)
D. Attach Upper Main Frame (D) to Rear Upper Beam (E) and Rear Upright (C) using:
Two 55 (10mm x 65mm hex head bolt)
Two 70 (10mm nylon lock nut)
E.
Attach Upper Main Frame (D) to Rear Upright (C) and Pulley Bracket (AD) using:
Two 55 (10mm x 65mm hex head bolt)
Two 70 (10mm nylon lock nut)
F. Attach Function Training Arm (H) as shown using:
Two 55 (10mm x 65mm hex head bolt)
Four 60 (10mm washer)
Two 70 (10mm nylon lock nut)
G. Attach one End Cap (17)* to Lower Main Frame (A) as shown.
Attach one End Cap (17)* to Upper Main Frame (D) as shown.
Attach two End Caps (17)* to Rear Upper Beam (E) as shown.
Attach two Foot Caps (46)* to Stabilizing Leg (P) as shown.
Attach two Foot Caps (46)* to Rear Leg (B) as shown.
*NOTE:
These parts might be pre-installed.
H.
You can now wrench tighten all bolts and nuts in this step.
Leave all pulley bolts hand tight until the final cable installation in Step 13 is completed.
MM
0 10
Inch
0
20 30 40 50
1 2
60 70 80 90
3
8
100 110 120 130
4 5
140 150
6