Upgrading Main Memory; Troubleshooting; Message Bios Update; The Screen Stays Blank - Fujitsu Siemens Computers D1218 Technical Manual

Upgrading main memory

Upgrading main memory
Support: The system needs at least one module.
Size: From 32 Mbytes up to 512 Mbytes SDRAM
Technology: PC100 or PC133 unbuffered DIMM modules.
168 pin, 3.3 V, 64 bit, 72 bit (with ECC), SDRAM
2 M, 4 M, 8 M, 16 M and 32 M x 64 bit
2 M, 4 M, 8 M, 16 M and 32 M x 72 bit
Granularity: For one socket 16, 32, 64, 128, 256 or 512 Mbyte
SDRAM modules with ECC can be plugged in but ECC is not functioning. Mix of
ECC modules with non ECC modules is possible.
Support for up to 2 single sided or 2 double sided DIMM modules.
Mix of PC100 and PC133 DIMMs is possible, but all modules will only work at PC100
speed.

Troubleshooting

Message BIOS update

The System BIOS provides optimum support for the processor you have chosen. If the message
BIOS update for installed CPU failed
appears the microcode required for the processor inserted must still be loaded. Further information
on this is available in the "BIOS Setup" manual on the "Drivers & Utilities" CD provided.

The screen stays blank

If your screen stays blank this may have the following cause:
The wrong RAM memory module has been inserted
Ê
See the chapter "Main Memory" for information which memory modules can be used.
ACPI S3 (Save-to-RAM) and/or ACPI S4 (Save-to-Disk) doesn't work
This system board is fully compliant for ACPI S3 and S4. Therefore it is PC99 certified by Microsoft.
If you have any problems with ACPI please ensure that all of your components are supporting
ACPI S3 and S4.
Operating system
Hardware and drivers of controllers (e. g. VGA, audio, LAN, SCSI controllers).
For further information please refer to http://developer.intel.com/technology/iapc/involve.htm .
16 - English
A26361-D1218-Z180-1-7619