Axis 262+ Rear Panel - Axis 262 User Manual

AXIS 262+ Product Description
8

AXIS 262+ rear panel

RS-232 connector
RS-232 connector - For the connection of a UPS (Uninterruptible Power Supply) unit. The
approved UPS model is Smart-UPS from APC.
Network connector - Connect the AXIS 262+ to your network using a standard CAT-5
network cable.
9-pin I/O terminal connector - Used to connect external devices, see I/O Terminal
Connector, on page 35 for more information.
Factory setup button - Used to reset the AXIS 262+ to the factory default settings, see
Resetting the AXIS 262+, on page 32.
Power button - To shut the AXIS 262+ down correctly, press and hold this button until a
"beep" sound is heard. Shutdown will then complete after approximately 20 seconds. To
start the unit, press the button once.
Power adapter connector - Connect the power supply cable to the AXIS 262+. The AXIS
262+ starts up automatically after connecting the power supply cable to a power source.
Important!
• Never disconnect the power cable when the AXIS 262+ is on
• Use the power button to switch off the AXIS 262+
Network connector 9-pin I/O terminal
connector
Factory setup button
Power adapter
connector
Power button