Table of Contents
Advertisement
AXIS 200+ and 240 User's Guide
The AXIS 240 Camera Server
The AXIS 240 is equipped with four coax/BNC video-in connectors
Video Inputs -
(CAM1-CAM4) and one S-video connector (Y/C). The video inputs are equipped with
signal autosensing to provide full connectivity to cameras using different video formats, e.g. NTSC,
PAL, Black/white 50Hz or Black/white 60Hz. Physical connections made using RG59, 75 ohm
coax cable Video Cable, have a recommended maximum length of 800 feet (250 m).
Each video input is normally terminated with a 75 ohm resistor via an
DIP Switches -
associated DIP switch, connected in the down-position. If the AXIS 240 is to be connected in
parallel with other equipment, disable the input termination by turning the corresponding DIP
switch to the up-position. Otherwise, the picture quality might be reduced.
I/O Connector -
output.
RS-232 Serial Connectors -
connection, typically to a Pan/Tilt device and modem.
Ethernet 10BaseT Connector -
connection to the network.
Power Supply Connector -
An alternative power connector is also provided.
Note:
The power supply supplied with your AXIS 240 is country specific. Please check that the type of
power supply you are using is correct. See page 25.
A Mini-DIN 8-pole external connector with four alarm inputs and one relay
Two 9 pin D-sub connectors providing RS-232 serial
10BaseT (RJ-45) twisted pair Ethernet connector for
Jack socket (PS-D) for connection of AXIS 240 power supply.
Appendix A - Hardware Inventory
27
Advertisement
Table of Contents
