Specifications - Denon AVP-A1HD Owner's Manual

GWireless LANH
Symptom Cause
Cannot connect • The settings of the
to network. and network key (WEP) are
incorrect.
• The reception is poor and the
signals cannot be received.
• There are multiple networks and
the usable channels overlap.
Played sound is • There are multiple networks and
interrupted or the usable channels overlap.
sound cannot be
played.
Countermeasure
SSID • Match the network settings with
the AVP-A1HD's settings.
• Shorten the distance from the
wireless LAN's access point,
remove any obstacles and
otherwise improve visibility, then
try reconnecting. Also install
away from microwave ovens
and the access points of other
networks.
• Set the access point's channel
settings away from the channels
used for other networks.
Alternatively, connect using a
network cable.
• Set the access point's channel
settings away from the channels
used for other networks.
Alternatively, connect using a
network cable.
Page
34, 35

Specifications

–
n
Audio section
• Analog
Input sensitivity / Input impedance:
Frequency response:
S/N:
Distortion:
Rated output:
–
• Digital
D/A output:
Digital input:
–
• Phono equalizer (PHONO input — REC OUT)
Input sensitivity:
RIAA deviation:
S/N:
Rated output:
Distortion factor:
n
Video section
• Standard video connectors
Input / output level and impedance:
Frequency response:
• S-Video connectors
Input / output level and impedance:
Frequency response:
• Color component video connector
Input / output level and impedance:
Frequency response:
RCA Pre output (unbalanced) : 200 mV / 47 kΩ/kohms
XLR Pre output (balanced) : 400 mV / 100 kΩ/kohms
10 Hz ~ 100 kHz +1, –3 dB (DIRECT mode)
102 dB (IHF–A weighted, DIRECT mode)
0.005 % (20 Hz ~ 20 kHz) (DIRECT mode)
RCA Pre output (unbalanced) : 1.2 V
XLR Pre output (balanced) : 2.4 V
Rated output — 2 V (at 0 dB playback)
Total harmonic distortion — 0.005 % (1 kHz, at 0 dB)
Dynamic range — 110 dB
Format — Digital audio interface
2.5 mV
±1 dB (20 Hz to 20 kHz)
74 dB (A weighting, with 5 mV input)
150 mV
0.03 % (1 kHz, 3 V)
1 Vp-p, 75 Ω/ohms
5 Hz ~ 10 MHz — +0, –3 dB (when video convert set to "OFF")
Y (brightness) signal — 1 Vp-p, 75 Ω/ohms
C (color) signal — 0.3 (PAL) / 0.286 (NTSC) Vp-p, 75 Ω/ohms
5 Hz ~ 10 MHz — +0, –3 dB (when video convert set to "OFF")
Y (brightness) signal — 1 Vp-p, 75 Ω/ohms
P / C signal — 0.7 Vp-p, 75 Ω/ohms
B B
P / C signal — 0.7 Vp-p, 75 Ω/ohms
R R
5 Hz ~ 100 MHz — +0, –3 dB (when video convert set to "OFF")