System Call Function; Punch Through Function - Denon AVP-A1HD Owner's Manual

Signal
transmission
indicator
[ AMP]
[SYSTEM CALL]
[CHANNEL+/–]
[NUMBER]
0

System Call Function

This function lets you register a series of operations at a single
button.
For example, the amplifier can be turned on, the input source
[MODE
selected, the monitor's power turned on, the source device's
SELECTOR]
power turned on and the play mode set all by pressing a single
button.
Up to 32 signals each can be registered at
3
or ).
Registering
1
[POWER ON]
[MODE SELECTOR]
Press
register.
2
Press and hold in
The signal transmission indicator flashes twice.
3
[9] [7]
Press ,
The signal transmission indicator flashes twice and the system
call registration mode is set.
[RC SETUP]
4
[SYSTEM CALL]
Press
register the signals.
5
Press the buttons you want to register in the same
sequence as the operations you want to perform.
The signal transmission indicator lights when a button is
pressed.
Example : Press
Press
[8], [9],
Press
b The mode can be switched by pressing
[1],
b Perform the registration procedure for all the buttons you want to
[6], [7],
register.
[3], [2]
6
Press and hold in
The signal transmission indicator flashes twice and the setting
is completed.
[SYSTEM CALL] 1
( ,
for the device you want to
[RC SETUP]
for at least 3 seconds.
[8]
and , in that order.
1 2 3
( , or ) at which you want to
[POWER ON]
.
↓
[MODE SELECTOR] [DVD]
– .
↓
[1]
.
[MODE SELECTOR]
.
[RC SETUP]
for at least 3 seconds.
Calling out
1
[AMP]
Press , to select "SYSTEM CALL".
2
[SYSTEM CALL] 1 2
Press ( ,
were registered.
The registered signals are transmitted in the registered
2
sequence.

Punch Through Function

CD, DVD or VCR mode buttons can be stored at unused TV or
SAT/CBL mode buttons.
For example, when DVD mode buttons are assigned to the TV
mode, the DVD mode operations can be performed while in the
TV mode.
1
[MODE SELECTOR]
Press for the device you want to
punch through (CD, DVD or VCR).
2
[RC SETUP]
Press and hold in
The signal transmission indicator flashes twice.
3
[9] [8] [4]
Press , and , in that order.
The signal transmission indicator flashes twice and the punch
through setting mode is set.
4
Press the button you want to punch through (1, 2,
6, 7, 8, 9 or 3).
5
[MODE SELECTOR]
Press for the device you want to
punch through (TV or SAT/CBL).
6
[RC SETUP]
Press and hold in
The signal transmission indicator flashes twice and the setting
is completed.
3
or ) at which the signals
for at least 3 seconds.
for at least 3 seconds.