Table of Contents
Advertisement
The VDSL2 Switch provide Web interface for Switch smart function configuration and make the VDSL2 Switch operate
more effectively - They can be configured through the Web Browser. A network administrator can manage and monitor the
VDSL2 Switch from the local LAN. This section indicates how to configure the VDSL2 Switch to enable its smart function.
4.1 Main Menu
Main menu appears at left side of the WEB browser interface after successfully login VC-810S. To enter any of the
submenus, simply move the cursor to the main function and click. When select further options, the configurable interface
shows at right side. The screen in
Via the Web-Management, the administrator can setup the VDSL2 Switch by select the functions those listed in the Main
Function. As listed at the left of the main screen, the configurable smart functions are shown as below:
System –
Port Management -
VLANs –
Quality of Service –
Multicast –
Address Learning Table – Configure MAC address table aging, aging time mode and 802.1d BPDU packet filter.
Port Mirroring -
Link Aggregation –
Statistics -
Storm Control -
Figure 4-1
appears.
Figure 4-1 Web Main screen
Check the hardware, software version and System MAC address. Setting the IP address,
Firmware Update and SNTP management for the VDSL2 Switch.
Setup per VDSL2 port mode, Rate Limit, SNR margin Port description.
Configure VLAN Member / Port Configuration.
Mapping the packet level to classify the packets priority.
Enables or disables IGMP Snooping on the device to filter the multicast stream.
Dedicated port monitoring for incoming packets.
Configure link aggregation groups. Up to 4 VDSL2 ports per link trunk group.
Display transmit, receive and CRC packets statistics of each port on the VDSL2 Switch.
Enable Storm Control function to reduce broadcast packets on the VDSL2 Switch.
User's Manual of VC-810S / VC-810S48
4. CONFIGURATION
24
Advertisement
Table of Contents
