Rear Panel; Hardware Installation - Planet FSD-804P User Manual

8-port 10/100mbps with 4-port poe fast ethernet switch

Hide thumbs Also See for FSD-804P:

Table of Contents

2.3 Rear Panel

The rear panel of the FSD-804P indicates an AC inlet power socket, which accepts input power from 100 to 240VAC,

50-60Hz, 1A max.

Power Notice:

1. The device is a power-required device, it means, it will not work till it is powered. If your networks should active all the

time, please consider using UPS (Uninterrupted Power Supply) for your device. It will prevent you from network data

loss or network downtime.

2. In some area, installing a surge suppression device may also help to protect your FSD-804P from being damaged by

unregulated surge or current to the FSD-804P or the power adapter.

2.4.1 Before start up

Before your installation, please refer to the followings for your cabling:

100Base-TX

All 100Base-TX ports come with Auto-Negotiation capability. They automatically support 100Base-TX and 10Base-T

networks. Users only need to plug a working network device into one of the 100Base-TX ports, and then turn on the

FSD-804P. The port will automatically runs in 10Mbps, 20Mbps, 100Mbps or 200Mbps after the negotiation with the

connected device.

Cabling

Each 10/100Base-TX ports use RJ-45 sockets -- similar to phone jacks -- for connection of unshielded twisted-pair

cable (UTP). The IEEE 802.3u Fast Ethernet standard requires Category 5 UTP for 100Mbps 100Base-TX. 10Base-T

networks can use Cat.3, 4, or 5 UTP (see table below). Maximum distance is 100meters (328 feet).

Port Type

10Base-T

100Base-TX

Any Ethernet devices like hubs/ PCs can connect to the FSD-804P by using straight-through wires. The

eight-10/100Mbps ports are auto-MDI/MDI-X can be used on straight-through or crossover cable.

Figure 2-2: FSD-804P Switch rear panel

Cable Type

Cat 3, 4, 5, 2-pair

Cat.5 UTP, 2-pair

Connector

RJ-45

- 7 -

Table of Contents