Ducati DESMOSEDICI RR Owner's Manual page 48

To set the rear brake pedal,
loosen check nut (4).
7 6
Turn pedal travel adjusting screw (5) until pedal is in the
desired position.
Tighten the check nut (4) to 2.3 Nm.
Work pedal by hand to make sure it has 1.5 - 2 mm free play
before brake begins to bite.
If not so, set the length of cylinder linkage as follows.
Loosen the screw (6) and tighten the eccentric (7) to increase
play, or unscrew to reduce it.
Tighten the screw (6) to 7.5 Nm and check play again.
E
5 4
fig. 37
48