USB data logger
This function lets you activate the USB data logger (see page
66): the data logger must be connected to vehicle wiring.
To enable this function, enter the menu and set "USB" data
logger to "On" by holding button (1, fig. 8) pressed in position
B "t" for 3 seconds.
The START/STOP control for the data logger lap separator is
the high-beam flasher button FLASH (12, fig. 5) on the LH
switch.
The USB function is disabled automatically if the key is
turned to Off (Key-Off) while it is active.
E
fig. 21
27