Pre-Ride Checks - Ducati 620 SPORT Owner's Manual

Important
During the whole running-in period, the maintenance
and service rules recommended in this manual should be
observed carefully. Have the service inspections
performed as recommended in the Warranty Card.
Failure to comply with these rules will release Ducati
Motor Holding S.p.A. from any liability whatsoever for
resulting engine damage or shorter engine life.
After 2500 km
After running-in, never exceed the following values
during the motorcycle standard use:
10,500 rpm.
Strict observance of running-in recommendations will
ensure longer engine life and reduce the likelihood of
overhauls and tune-ups.

Pre-ride checks

Warning
Failure to carry out these checks before riding, may
lead to motorcycle damage and injury to rider and
passenger.
Before riding, perform a thorough check-up on your bike
as follows:
Fuel level in the tank
Check fuel level in the tank.
Fill tank if needed (page 38).
Engine oil level
Check oil level in the sump through the sight glass. Top
up if needed (page 60).
Brake and clutch fluid
Check fluid level in the relevant reservoirs.
Tyre condition
Check tyre pressure and condition (page 58).
Controls
Work the brake, clutch, throttle and gear change controls
(levers, pedals and twistgrips) and check for proper
operation.
Lights and indicators
Make sure lights, indicators and horn work properly.
Replace any burnt-out bulbs (page 53).
Key-operated locks
Check that fuel filler plug and seat catch locks are closed
firmly.
Stand
Make sure side stand operates smoothly and is in the
correct position (page 29).
Warning
In case of malfunctioning, do not start the
motorcycle and call a Ducati Dealer or authorised
workshop.
E
33