Table of Contents
Advertisement
Unless the LAN Only is selected, you can choose one of the three options, Static IP, DHCP, and
PPPoE from the Type list for your configuration. Select LAN Only check box to disable WAN, and only
default router and DNS settings are applicable. Select MAC Clone to change the WAN MAC address.
Select Yes to allow WAN to respond PING request.
4.3.1 Static IP
You can click Static IP in the Type list, and manually configure the following information:
•
IP Address
•
Netmask
•
Default gateway IP address
•
Primary, secondary or third DNS servers
Click Apply to submit.
4.3.2 DHCP
Simply click DHCP in the Type list, and click Apply. The acquired IP address, netmask, default
gateway and DNS server information will show when revisit this page later.
4.3.3 PPPoE
1.
Click PPPoE in the Type list.
2.
Enter a user name and its password in User Name and Password boxes.
3.
Click Apply.
The PPPoE dialing will start right away. When there is an active connection, the page will show the
acquired IP address, network mask, default gateway and DNS server information.
4.3.4 Allow WAN to Respond PING
Select this option if appropriate and click Set. If enabled, the WAN port of IP PBX will respond PING to
the originator.
4.3.5 LAN Only
Select LAN Only to disable WAN IP settings but allow the configuration of default gateway and
primary/secondary/third DNS servers.
23
Advertisement
Table of Contents
