Table of Contents
Advertisement
3 Wizard Configuration
With IP PBX Wizard configuration, the administrator can set basic configurations for IP PBX easily.
With basic setup, IP PBX can function, and connect to the relevant devices and trunks. The Wizard
Configuration including Add Account Wizard, Add Route & Trunk and Mass Extension Adding.
When entering Wizard configuration, you will see
you to configure with Wizard. Any configuration change in Wizard requires clicking
bottom of the homepage.
3.1 Add Account Wizard
In Add User & Device page, the administrator can setup usergroups, users and devices. You can
follow the following steps to finish configuration. After finishing configuration, click
bottom of the homepage to take the configuration effect.
Step 1: Add User Group
1.
Enter a group ID and then click ADD.
2.
The name will show in the table of the webpage.
3.
Click the name to view the edit page.
4.
Enter settings shown in Table 3-1.
5.
Click Back to return to the ADD USER GROUP page.
For deleting a usergroup, select a group ID and click DEL.
Note: Make sure there is no user associate with the usergroup, or it cannot be deleted.
Click Next to add a user.
Table 3-1Add Usergroup Settings
Field
Description
at the bottom of each page that helps
Description
Arbitrary description information. Click SET to add/update
4
at the
at the
Advertisement
Table of Contents
