Table of Contents
Advertisement
5.5 DHCP Service
Select Service -> DHCP Service to view the current status of the DHCP Service. You can enable or
disable the DHCP Service at any time.
Note: If the IP PBX was shut down abnormally, Select Service -> DHCP Service and click Apply, or
Go to Service -> IP PBX Service, and click Restart to activate the DHCP service.
5.5.1 DHCP Service
5.5.1.1 Enable DHCP Service
Click Enable, choose the main interface offering addresses, and then Apply to configure DHCP
settings.
5.5.1.2 Disable DHCP Service
Click Disable and click Apply.
5.5.2 Add New
5.5.2.1 Add DHCP Range
1.
Click Add New tab.
2.
Enter a pool name (must have an alphabet initial) in Pool Name.
3.
Select Range or Single-host to enter an IP address of the host with MAC, if the binding is
intended for a specific host only.
4.
Enter a DHCP range of addresses available for lease in IP. The right address box will not show if
Single-host is selected.
5.
Optionally, DHCP options
Code,Value and click
option, choose it from the Options list and click
6.
Click Add at the bottom of the page to commit changes.
You can see the newly added DHCP POOL displayed in the DHCP POOL list.
5.5.2.2 Edit DHCP Range
1.
Click any pool name in the DHCP POOL list to see the settings on the right.
16
Refer to RFC 2132 for the details of available DHCP options.
16
could be configured by entering an option code and value in
. The new DHCP option will show in the Options list. To delete an
37
after the box.
Advertisement
Table of Contents
