Table of Contents
Advertisement
A. Connect one end of a standard network cable to the 10/100/1000 RJ-45 ports on the
front of the Gigabit Ethernet Switch.
B. Connect the other end of the cable to the network devices such as printer servers, work-
stations or routers...etc.
Connection to the Gigabit Ethernet Switch requires UTP Category 5
network cabling with RJ-45 tips. For more information, please see
the Cabling Specification in Appendix A.
Note
Step 5: Supply power to the Gigabit Ethernet Switch.
A. Connect one end of the power cable to the Gigabit Ethernet Switch.
B. Connect the power plug of the power cable to a standard wall outlet.
When the Gigabit Ethernet Switch receives power, the Power LED should remain
solid Green.
2.2.2 Rack Mounting
To install the Gigabit Ethernet Switch in a 19-inch standard rack, follow the
instructions described below.
Step 1: Place your Gigabit Ethernet Switch on a hard flat surface, with the front
panel positioned towards your front side.
Step 2: Attach a rack-mount bracket to each side of the Switch with supplied
screws attached to the package. Figure 2-5 shows how to attach brackets
to one side of the Gigabit Ethernet Switch.
Figure 2-5 Attaching the brackets to the Gigabit Ethernet Switch
You must use the screws supplied with the mounting brackets.
Damage caused to the parts by using incorrect screws would invali-
date your warranty.
Caution
Step 3: Secure the brackets tightly.
10
Advertisement
Table of Contents
