Table of Contents
Advertisement
4.Troubleshooting
This chapter contains information to help you solve issues. If the Gigabit Ethernet
Switch is not functioning properly, make sure the Gigabit Ethernet Switch was set
up according to instructions in this manual.
The per port LED is not lit
Check the cable connection of the Gigabit Ethernet Switch.
Solution
Performance is bad
Check the speed duplex mode of the partner device. The Gigabit
Ethernet Switch is run at Auto-negotiation mode and if the partner
is set to half duplex, then the performance will be poor.
Solution
Per port LED is lit, but the traffic is irregular
Check that the attached device is not set to dedicate full duplex.
Some devices use a physical or software switch to change duplex
modes. Auto-negotiation may not recognize this type of full-duplex
Solution
setting.
Why the Gigabit Ethernet Switch doesn't connect to the network
Check per port LED on the Gigabit Ethernet Switch. Try another
port on the Gigabit Ethernet Switch Make sure the cable is installed
properly Make sure the cable is the right type Turn off the power.
Solution
After a while, turn on power again.
14
Advertisement
Table of Contents
Need help?
Do you have a question about the GSW-1601 and is the answer not in the manual?
Questions and answers