Transmission Oil Change (2:1 Reduction Type) - Honda GX240 Owner's Manual

SERVICING YOUR ENGINE
TRANSMISSION OIL CHANGE
(2 : 1 reduction transmission with centrifugal clutch)
Drain the used oil while the engine is warm. Warm oil drains quickly
and completely.
1. Place a suitable container below the transmission to catch the used
oil, then remove the filler cap/dipstick and the drain plug.
2. Allow the used oil to drain completely, then reinstall the drain plug,
and tighten it securely.
Please dispose of used motor oil in a manner that is compatible with
the environment. We suggest you take used oil in a sealed container
to your local recycling center or service station for reclamation. Do
not throw it in the trash, pour it on the ground, or down a drain.
3. With the engine in a level position, fill to the upper limit mark on the
dipstick with the same oil that is recommended for the engine (see
page 28). To check the oil level, insert and remove the dipstick
without screwing it into the filler hole.
Transmission oil capacity:
Running the engine with a low transmission oil level can cause
transmission damage.
4. Screw in the filler cap/dipstick securely.
UPPER LIMIT
LOWER LIMIT
30
0.32 US qt (0.30 )
FILLER CAP/DIPSTICK
DRAIN PLUG