Oil Change; Oil Filter - Honda GXV630 Owner's Manual

37ZCS6030.fm 8 ページ ２０１９年１１月１日 金曜日 午後６時３０分

Oil Change

Drain the used oil when the engine is warm. Warm oil drains quickly and
completely.
1. Place a suitable container below the engine to catch the used oil,
then remove the oil filler cap/dipstick, drain bolt and sealing washer.
2. Allow the used oil to drain completely, then reinstall the drain bolt
and new sealing washer, and tighten the drain bolt securely.
TORQUE: 45.0 N·m (4.5 kgf·m, 33 lbf·ft)
Please dispose of used motor oil in a manner that is compatible with
the environment. We suggest you take used oil in a sealed container
to your local recycling center or service station for reclamation. Do
not throw it in the trash, pour it on the ground, or pour it down a
drain.
3. With the engine in a level position, fill with the recommended oil to
the upper limit mark on the dipstick.
Engine oil capacity:
Without oil filter replacement: 1.7 L (1.8 US qt, 1.5 lmp qt)
With oil filter replacement: 1.9 L (2.0 US qt, 1.7 lmp qt)
Running the engine with a low oil level can cause engine damage. This
type of damage is not covered by the Distributor's Limited Warranty.
4. Reinstall the oil filler cap/dipstick securely.
8
OIL FILLER CAP/
DIPSTICK
UPPER LIMIT
LOWER LIMIT
OIL DRAIN BOLT
SEALING WASHER
(Replace)
ENGLISH

OIL FILTER

Change
1. Drain the engine oil, and retighten the drain bolt securely.
2. Remove the oil filter with an oil filter socket tool and drain the
remaining oil into a suitable container. Dispose the used oil and filter
in a manner compatible with the environment.
Use an oil filter socket, rather than a strap wrench, to avoid striking and
damaging the oil filter.
OIL FILTER
OIL FILTER SOCKET
3. Clean the filter mounting base, and coat the seal of the new oil filter
with clean engine oil.
Use only a Honda Genuine oil filter or a filter of equivalent quality
specified for your model. Using the wrong filter, or a non-Honda filter
which is not of equivalent quality, may cause engine damage.
4. Screw on the new oil filter by hand until the seal contacts the filter
mounting base, and then use an oil filter socket tool to tighten the
filter an additional 3/4 turn.
Oil filter tightening torque: 12 N·m (1.2 kgf·m, 9 lbf·ft)
5. Refill the crankcase with the specified amount of the recommended
oil (see page 7). Reinstall the oil filler cap/ dipstick.
6. Start the engine, and check for leaks.
7. Stop the engine, and check the oil level as described on page 7. If
necessary, add oil to bring the oil level to the upper limit mark on the
dipstick.
SEAL
FILTER MOUNTING BASE